Areas of Use

It is used inside the building, on colored quartz anti-slip coatings, in transparent topcoat floor coating systems with high UV resistance.

Features and Advantages

Easy to apply.

Transparent.

UV and weather resistant.

Low viscosity.

Solvent free.

They have high mechanical strength.

Water, seawater, waste water, alkalis, acid solutions, saline

resistant to water, mineral oils and fuels.

Polymex-5005 is supplied in ready-to-use sets according to the mixing ratio. Before mixing, make sure that the material temperature is between +15/+25°C.

Component A should be thoroughly mixed with a 300 - 400 rpm mechanical mixer fitted with Epoxy/Polyurethane Resin mixing tip for 3 - 4 minutes without entraining air. Then, all of the B component should be poured into the A component and make sure that there is no material left in the B component. Polymex- 5005; A+B should be mixed for at least 3 minutes until a homogeneous mixture is obtained. The material on the sides and bottom of the mixing container must be thoroughly mixed.

Put the ingredients from the first mixing bowl into a clean bowl and stir for a while.
rest and stir again for about 1 minute and use.

Polymex-5005; the coating surface to be applied must be free from dust, dirt, oil and other substances that may prevent adhesion. The application should be made within the recoating period of the coating system. In case of application on old coatings, our Technical Service should be consulted for the application method.

The application surface should have a tensile strength of 1.5 N/mm2 and a maximum humidity of %4. It should be ensured that the ground temperature is above +3 °C above the humidity point and it should be ensured that it will be this way for at least 6 hours.

Polyurea Insulation Restrictions:
The packaging must not be opened until the components are used.

Polyurea Insulation Notes
All technical data contained in this product data sheet are based on laboratory experiments. Actual data may vary due to conditions beyond the control of AŞY POLYMEKS KİMYA SAN TİC LTD ŞTİ.

All technical data contained in this product data sheet are based on laboratory experiments. Actual data may vary due to conditions beyond the control of AŞY POLYMEKS KİMYA SAN TİC LTD ŞTİ. Polyurea Primer Polyurea - Epoxy - Polyurethane is used in Floor Primer of Floor Coatings and Insulations. The floor is cleaned and 250-300.gram per m2 should be applied to the cleaned floor. Insulation or floor covering materials are used on it. Polyurea Floor Primer is used in risky areas. According to the seasonal conditions and the structure of the usage area, primer with different properties is used.