Ready for use.

Allows inhalation on surfaces.

Likit Membran %600 Elastiktir.

Tensile strength24.5 kgf/cm at 23'C after 24 hours² 55 kgf/cm after 72 hours²

It is applied with Brush Roller Trowel.

It is not affected by sunlight.

It retains its elasticity even at low temperatures.

Provides high adherence.

Easy and fast to apply.

Resistant to freeze-thaw cycles.

Paintable

Absolutely Solvent-free

Antistatic and antibacterial.

Application Areas:

Especially in vertical and horizontal applications in outdoor areas
Sloping Terrace balcony roofs
Under tile or above tile insulation
Concrete zinc and precast chimneys and gutters
North exterior facade of buildings and Silo warehouses
Pool insulation
Foundation basement insulation
Drinking Water Tanks
Insulation under spray polyurethane and over spray polyurethane
Insulation of Bathrooms and Wet Areas
Outdoor garden foundation and terrace insulation
Insulation of corner parapets

Implementation:

Surface Preparation:

The surface to be treated with Liquid Membrane must be dry and cleaned thoroughly from dirt, oil, rust, etc. The surface must be dry and clean on concrete or sheet iron, fiberboard, wood and tile surfaces. Old and worn surfaces (worn, loosened and lost mechanical strength) should not be primed before the necessary repairs are made. The concrete must be set and completely dry. Uneven surfaces should be repaired with suitable repair mortars. Corner edges of the surfaces must be chamfered with repair mortar with a diameter of 4cm. Water flow towards the drains must be ensured.

Implementation:

Polymex-1016 should be applied 4 hours after the primer is applied to the floor, after making sure that the floor has hardened. Two coat application is sufficient. If necessary, 3 coats can be applied. After application, a 2mm thick dry film layer is obtained. The applied surface should not be wetted, walked on and protected for at least 12 hours. Do not apply without primer, apply Polymex-1016 on the dry primer 4 hours after the primer is applied.

Polymex-1016; Kullanıma hazır bir malzemedir. Astar uygulamasında Polymex-1016’a %50 su ile 400-600 devir/dak bir karıştırıcı ile 3-5 dakika karıştırılmalı ve hazırlanan malzeme Astar olarak zemine 250 gram/m² should be applied. 4 hours after the primer application, other coats should be applied in the 1st coat. 1.5 mm wet film thickness should be applied with a roller, brush or trowel. Cracks, joints, corners and edges should be supported with 100 gr or 165 gr suitable waterproofing mesh or fiber felt after the first coat application.

Consumption:

For 1 mm dry film thickness: 1.40 kg/m²
For 1 mm wet film thickness: 1.3 kg/m²
For the thickness of gutters and gutters : 2 kg/m²
On terraces and floors: 2.5 kg/m²

Polyurea Insulation Notes
All technical data contained in this product data sheet are based on laboratory experiments. Actual data may vary due to conditions beyond the control of AŞY POLYMEKS KİMYA SAN TİC LTD ŞTİ.